20
www.pridemobility.com
Jet12/RevC/Feb03
V . Y O U R J E T 1 2
Specifications
Suspension:
Limited
Drive Wheels:
14 in., solid tires
Rear Casters:
8 in., solid, rear articulating
Anti-tip:
6 in., solid, front mounted
Maximum Speed:
3.75 mph
Brakes:
Electronic regenerative, “Intelligent Braking”
Ground Clearance:
2.5 in.
Turning Radius:
20 in.
Overall Size:
Length: 44.5 in.
Width: 24.5 in.
Seating Options:
Sling Back and Sling Seat
Drivetrain:
Two-motor, mid-wheel
Batteries:
Two 12-volt, NF-22 batteries
Range:
Up to 25 miles per full charge
Battery Charger:
On-board 4-amp
Motor Controller:
Dynamic DL-50
Weight Capacity:
250 lbs.
Jet 12 Weights:
Base: 77 lbs.
Batteries: 24 lbs. each
Total: 125 lbs.
Warranties:
Five-year limited warranty on frame
Two-year warranty on drivetrain
One-year warranty on electronics
ELECTRICAL CONNECTORS AND COMPONENTS
Your Jet 12 has four main electrical connectors; 9-pin controller connector, charger connector, front battery
box connector, and rear battery box connector. See figures 2225. The 9-pin controller connector, charger
connector, and rear battery box connector are located above the right caster wheel. The front battery box
connector is located above the right freewheel lever. Additional electrical components include the main
circuit breaker, the battery charger, the ammeter, and the charger circuit fuse. The main circuit breaker is
located on the front battery box. The battery charger is mounted inside the rear battery box.
9-pin Controller Connector:
This is where the controller connects to the motors, motor brakes, and
batteries.
Battery Box Connectors:
This is where the battery boxes connect to the power base. There are front and
rear battery connectors.
Main Circuit Breaker:
The main circuit breaker is a safety feature built into your Jet 12. It is located on
the front battery box. When the batteries and the motors are heavily strained (e.g., from excessive loads),
the main circuit breaker will trip to prevent damage to the motors and the electronics. If the circuit breaker
trips, allow the Jet 12 to rest for approximately one minute. Then, push in the circuit breaker button, turn
on the controller power, and continue normal operation. If the main circuit breaker continues to trip repeatedly,
contact your authorized Pride provider.