22
www.pridemobility.com
Jet1 HD/Rev H/Feb03
V . A S S E M B L Y
Figure 10. Electronics Tray Connections
PLUG IN CONTROLLER (A)
AND CHARGER INHIBIT (B).
Figure 9. Seat Installation
Figure 8. Seat Post
Seat Installation
To install the seat:
1. Set the seat on the seat post. See figure 8.
2. Push the seat down until the latch engages. See figure 9.
3. Plug the controller and charger inhibit into the connector
on the electronics tray. See figure 10.
Charger Inhibit Plug Connection
The charger inhibit connector, located on the electronics tray, is
coded with colored dots. The dots are positioned so that the
flat side of the male connector aligns with the flat side of the
female connector while making the connection. See figure 11.
WARNING! Failure to properly align the con-
nectors can result in damage to the control-
ler, the charger, the charger harness and the
connectors.
Controller Installation
Your Jet may have been shipped without the controller in-
stalled in the armrest.
To install the controller:
1. Use a 3/16 in. hex key to loosen the setscrew. See figure 12.
2. Slide the controller mounting bracket into or out of the
armrest to the desired position.
3. Retighten the setscrew by turning it clockwise.
A
B
CAUTION! Do not place the controller cable so
that it can be pinched in the seat frame or the
power base frame.
