Jet1 HD/Rev H/Feb03
www.pridemobility.com
25
V I . C O M F O R T A D J U S T M E N T S
Figure 16. Armrest Angle And
Controller Extension Adjustment
Armrest Height Adjustment (op-
tional)
Your Jet may be equipped with height-adjust-
able armrests. See figure 15.
To change the armrest height:
1. Loosen the setscrew located underneath the
armrest.
2. Raise or lower the armrest to the desired
position.
3. Tighten the setscrew.
Armrest Angle Adjustment
You can adjust the armrest angle to fit your spe-
cific needs. See figure 16.
To change the armrest angle:
1. Lift the armrest straight up so that it is per-
pendicular to the floor.
2. Use a 1/2-in. wrench to loosen the jam nut.
See figure 16.
3. Use a 1/2-in. wrench to loosen the adjust-
ing screw.
4. Turn the screw clockwise to lower the front
of the armrest, or turn the screw counter-
clockwise to raise the front of the armrest.
5. Lock the adjusting screw into place by tight-
ening the jam nut.
Controller Extension
Adjustment
The controller can easily slide out away from
the armrest, or in toward the armrest. See fig-
ure 16.
To extend the controller:
1. Use a 5 mm hex key to loosen the setscrew.
2. Slide the joystick mounting bracket into or
out of the armrest to the desired position.
3. Tighten the setscrew.
LOOSEN THIS SETSCREW
TO ADJUST CONTROLLER.
TURN THIS SCREW TO
CHANGE ARMREST
ANGLE.
JAM NUT LOCKS
ADJUSTING
SCREW IN PLACE.
