26
www.pridemobility.com
Jet1 HD/Rev H/Feb03
V I . C O M F O R T A D J U S T M E N T S
Figure 17. Footrest Height
REMOVE THESE NUTS AND BOLTS
TO RAISE OR LOWER THE FOOTREST.
Figure 18. Footrest Angle
TURN SETSCREW TO
CHANGE FOOTREST ANGLE.
SFR
RELEASE
LEVER
Figure 19. Swing-away Footrests
Footrest Height
The footrest height is easily adjusted to one of six different
heights in 1-inch increments.
To raise or lower the footrest:
1. Remove the two 7/16-in. bolts and their nuts from the
footrest. See figure 17.
2. Raise or lower the footrest to the desired height.
3. Install the two 7/16-in. bolts and nuts into the footrest
and tighten.
Footrest Angle
You can adjust the angle of the footrest with a 7/32-in. hex
key and a 1/2-in. box wrench. See figure 18.
To adjust the footrest angle:
1. Loosen the jam nut.
2. Turn the setscrew clockwise to lower the front of the foot-
rest.
3. Turn the setscrew counterclockwise to raise the front of
the footrest.
4. Tighten the jam nut.
Swing-away Footrests Option
Swing-away Footrests (SFRs) are an option. They enable you
to move the footrests to the side before getting off your Jet.
To move the SFRs:
1. Push in the release lever. See figure 19.
2. Move the SFRs.
Elevating Leg Rests Option
Elevating Leg Rests (ELRs) offer an infinite range of adjust-
ment for the leg angle and a footrest adjustment range of
12 19 in.
To adjust the ELR angle:
1. Press the release lever. See figure 20.
2. Move the leg rest to the desired angle.
To adjust the ELR footrest length:
1. Remove the two screws from the side of each leg rest
extension. See figure 21.
2. Loosen the bolt on the side of each leg rest extension.
JAM NUT
