24
www.pridemobility.com
J
et 2 HD
V I I . O P E R A T I O N
VSI ELECTRONIC CONTROLLER
The electronic controller is what you use to operate your power chair. The electronic controller enables you to
move the power chair, as well as monitor battery charge, electronic controller functions, and the condition of your
electrical system. The VSI electronic controller is an integral electronic controller. All of the electronics necessary
to operate the power chair are contained in one module. See figure 21. Typically, the VSI is mounted to one of the
armrests and is connected to the motors, batteries, and the onboard charger at the power base.
The controller supplied with your power chair has been pre-programmed to meet the needs of the end user. The
program is set using either a personal computer with software provided by the controller manufacturer or with a
hand-held programmer, also provided by the controller manufacturer.
WARNING! The controller program can affect speed, acceleration, deceleration, and brak-
ing. If it is programmed incorrectly or outside of the safe limits as determined by your
healthcare professional, it can create a dangerous situation. Only the power chair manu-
facturer, an authorized representative of the manufacturer, or a trained service techni-
cian should program the controller.
The VSI consists of:
1. joystick
2. keypad
3. off-board charger/programming socket
4. controller connector
5. charger inhibit connector
Joystick
The joystick controls the direction and speed of your
power chair. When you move the joystick from the
neutral (center) position, the electromagnetic brakes
release and allow your power chair to move. The
farther you push the joystick from its neutral posi-
tion, the faster your power chair moves. When you
release the joystick and allow it to return to the neu-
tral position, you engage the electromagnetic brakes.
This causes your power chair to decelerate and come
to a complete stop.
WARNING! If your power chair begins
to move in an unexpected manner,
immediately release the joystick.
Unless the joystick is damaged, this
action should stop your power chair.
Keypad
The keypad is located in front of the joystick. It contains keys necessary to operate your power chair. See figure 22.
Figure 21. VSI Controller
