32
www.pridemobility.com
J
et 2 HD
CARE AND MAINTENANCE
Your Jet 2 HD is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks.
You can perform some of these checks, but others require assistance from your authorized Pride Provider. Preven-
tive maintenance is very important. If you follow the maintenance checks in this section as scheduled, you can help
ensure that your power chair gives you years of trouble-free operation. If you have any doubt as to your power
chair’s care or operation, contact your authorized Pride Provider.
WARNING! Prevent injury. Do not service the power chair when the seat is occupied.
Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp
areas of any kind.
WARNING! Direct exposure to water or dampness could cause the power chair to malfunction
electronically and mechanically. Water can cause electrical components to corrode and the chair’s
frame to rust.
Should your power chair come in contact with water:
1. Dry your power chair as much as possible with a dry towel.
2. Allow your power chair to sit in a warm dry place for twelve hours to allow unseen water to evaporate.
3. Check the joystick operation and the brakes before using your power chair again.
4. If any inconsistencies are found, take your power chair to your authorized Pride Provider.
Temperature
!
Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your
power chair between the temperatures of 18° F and 122° F.
!
In extremely cold temperatures the batteries may freeze. The specific temperature at which they will freeze
depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., AGM
or Gel-Cell).
!
Temperatures above 122° F may cause your power chair to operate at a reduced speed. This is a safety
feature built into the controller that helps prevent damage to the motor and other electrical components. See
VII. “Operation.”
General Guidelines
!
Avoid knocking or bumping the controller, especially the joystick.
!
Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.
!
Keep the controller clean.
!
Check all controller connectors on the electronics tray to ensure that they are all tight and secured properly.
!
Use a rubber conditioner on the tire sidewalls to help preserve them. Check for wear.
Never use a rubber conditioner on the tread area of the tires; doing so may make the tires slippery
and cause your power chair to skid.
!
Make sure the drive tires are inflated to 35 psi (2.4 bar).
WARNING! Overinflating tires can cause them to explode and can result in personal injury.
WARNING! Do not use a high pressure hose to inflate your tires.
I X . C A R E A N D M A I N T E N A N C E
