10 Lift Chair Series
Your lift chair may require some assembly before initial use. It may also require disassembly to make
servicing the chair more convenient. If your lift chair is a Knock-Down (KD) model, follow the instructions
in “Lift Chair Setup.”
CHAIR BACK ASSEMBLY
NOTE: If your lift chair is an Infinite model, refer to the assembly instructions provided with the chair.
For the 2-position model, the KD sleeves are located on the inside as shown in figure 4.1.
I V . A S S E M B L Y / D I S A S S E M B L Y
BARIATRIC MODEL
WALL HUGGER MODEL
3-POSITION MODEL
INFINITE MODEL
HOOK AND LOOP FLAP
PROPER CLIP POSITION
2-POSITION MODEL
Figure 4.1 Lift Chair Assembly
1. Check that the locking clip on the back of the chair is in the vertical position. Reposition if necessary.
2. Drape the hand control and cable over the chair base, then slide the back onto the base.
Summary of Contents for LIFT CHAIR Series
Page 1: ...LIFT CHAIR...
Page 36: ......
