22
www.quantumrehab.com
Quantum 1402
I V . A S S E M B L Y
Power Seat Option Installation
Your power chair may be equipped with the power seat option.
While the seat itself may be any one of the styles offered for this
model, the way the seat base attaches to the Quantum 1402 power
base is different.
To install the power seat:
l. Align the seat post on the seat base to the hole in the actuator.
See figure 11.
2. Insert the seat post into the actuator and push the seat lever
forward.
3. Lock the seat into place.
Figure 11. Power Seat Actuator
To install the seat:
1. Set the trapeze bars to the desired height. To change the trapeze bar height, see V. “Comfort Adjustments.”
2. Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 10.
3. Lower the front extrusion onto the front trapeze bar until the seat locks into place.
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch safety is flipped down before using your power chair.
5. Install the controller into one of the armrests. See V. “Comfort Adjustments.”
6. Route the controller cable to the rear of the power base.
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or power
base frame.
7. Slide the rear cover open to expose the electronics tray.
8. Plug the controller connector into the electronics tray. See figure 6.
9. Secure the controller cable to the armrest receiver with one or more wire ties.
