26
www.quantumrehab.com
Quantum 1402
V . C O M F O R T A D J U S T M E N T S
Figure 17. Foot Platform Height/Depth Adjustment
Figure 18. Foot Platform Angle Adjustment
SETSCREW
FOOT PLATFORM
BRACKET NUTS AND
BOLTS
BALL DETENT
PIN
Foot Platform Height Adjustment
The foot platform height is easily adjusted to one
of six different heights in 1-in. (2.54 cm) incre-
ments.
To raise or lower the foot platform:
1. Remove the nuts and bolts from the foot plat-
form bracket. See figure 17.
2. Raise or lower the foot platform to the desired
height.
3. Reinstall the bolts and nuts into the foot plat-
form bracket and retighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the nuts and bolts from the foot platform
bracket. See figure 17.
2. Move the foot platform in or out to the desired
depth.
3. Reinstall the nuts and bolts into the foot plat-
form bracket and retighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with
a hex key. See figure 18.
To adjust the foot platform angle:
1. Locate the setscrew on the underside of the foot
platform.
2. Turn the setscrew to raise or lower the front of
the foot platform.
7. Place the controller in the other armrest.
8. Tighten the setscrew.
9. Use a wire tie to secure the controller cable to
the armrest.
10. Plug the controller connector into the electron-
ics tray.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or a TRU-Balance Power
Positioning System, refer to the information pro-
vided in separate manuals.
