28
www.quantumrehab.com
Quantum 600
V . C O M F O R T A D J U S T M E N T S
Figure 19. Underside of Foot Platform
SETSCREW
LOCKING NUT
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex key.
See figure 19.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the setscrew and
locking nut.
2. Loosen the locking nut.
3. Turn the setscrew to raise the front of the foot platform
or to lower the front of the platform.
4. Tighten the locking nut to secure the setscrew.
Figure 20. Positioning Belt Adjustment
Positioning Belt
Your power chair may be equipped with a positioning belt
that can be adjusted for operator comfort. See figure 20.
The positioning belt is designed to support the operator so
that he/she does not slide down or forward in the seat. The
positioning belt is not designed for use as a restraining device.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to
the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through
the positioning belt and into the seat base for each side
of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt
into the plastic housing on the opposite side until you
hear a click. See figure 20.
2. Pull the excess strap attached to the metal tab until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning
belt is properly secured to the power
chair and is adjusted for operator
comfort before each use.
MANDATORY! Inspect the positioning
belt for loose or damaged parts before
each use of the power chair. If you
discover a problem, contact your
Quantum Rehab Dealer for maintenance
and repair.
