Quantum Jazzy 1650 Series
www.pridemobility.com
21
I V . A S S E M B L Y
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation. It may also require disassembly
to make some comfort adjustments.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon
insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores
or through your authorized provider/specialist.
Seat Installation
The power chair seat is attached to the power base by four seat pins. Each pin is inserted into a receiver on the power base
frame. The seat pins have holes that enable you to adjust the seat height. Ball detent pins are inserted through the receiver
and through the seat pins to secure the seat
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose
control of the seat if they do so.
Figure 9. Seat Installation/Removal
SEAT TOWER
SEAT
RECEIVER
POWER BASE
BALL DETENT PIN
CONTROLLER
MOUNT
