Quantum Jazzy 1650 Series
www.pridemobility.com
23
V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase
your comfort, such as seat height and angle, foot platform height and angle, and controller position.
NOTE: If your power chair is equipped with a Synergy Seating System, refer to the seat adjustment informa-
tion contained in separate manuals. If your power chair is equipped with a contoured seating system, refer to
the following information.
WARNING! If your power chair was configured by your authorized provider/specialist, please consult
your healthcare professional before changing the seat position or making any other adjustment.
Some adjustments may degrade your power chair’s performance and safety by changing its center
of gravity.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort adjustments:
!
metric/standard socket set and ratchet
!
adjustable wrench
Seat Height and Seat Angle Adjustment
The seat is attached to the power base by four seat pins. You can change the seat height to one of four positions by raising
the front and rear seat pins. If you raise or lower only one set of seat pins (front or rear), you can also change the seat base
angle (dump).
To change the seat height or seat angle:
1. Turn off the power to the controller.
2. Make sure the power chair is in drive mode. See III. “Your Power Chair.”
3. Remove the ball detent pins from the seat receivers. See figure 9.
4. Move the seat up or down to the desired height.
NOTE: Change the seat dump by raising or lowering only one set of pins (front or back).
5. Reinstall the ball detent pins.
