User Manual (Page 25 of 30)
6. INSPECTION AND MAINTENANCE
Attention
１
.
When tread depth is below 0.5mm it can easily lead to vehicle slippage, increasing braking
distances. Therefore replace the tires as early as possible when they do not have sufficient tread
depth.
２
.
The tire pressure shall be kept at about 26 PSI (approx. 1.8KG/cm) for the best ride and handling.
Attention
When conducting maintenance of your vehicle, please turn the power switch to OFF and remove the
charger cords.
Suggestions
Do not splash water directly to wash your scooter as this could lead to malfunction of the
system electronics.
Do not use gasoline, solvents, or vaporizing solution as these may deform or damage the shrouds.
Do not use wax.
6.4 STORAGE
Make sure the vehicle is stored under the following circumstances:
-
Make sure the seat is set in the “Forward
”
position
-
Make sure the Power switch is turned to OFF
Suggestion
Please store the scooter in a location where it is away from the direct sunlight, rain, or dew. When
storing for a long time, please charge the battery to full power and then disconnect the battery
terminal. For details inquire to your scooter dealer.
6.5 MOVING ABOUT
Turn the power switch “OFF” before moving.
Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could
cause damage or injury.
For your safety, always ask for help if required. You will need 2 or 3 persons when moving or lifting
the vehicle.
