25
Victory
V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
Frame Separation
1. Push back on the seat post to pivot the scooters rear
section backwards until the rear section is standing
vertically on its rear bumper. See figure 17.
2. Lift the front section up until the lower pegs are no
longer in the slots. See figure 18.
3. Carefully lift the front section vertically away from the
rear section.
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 19.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section. See
figure 18.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 18.
4. Raise the tiller.
5. Secure the toggle latch. See figure 15.
n
Lower the toggle latch buckle.
n
Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear cable and both battery har-
nesses.
7. Replace the rear shorud.
8. Replace the seat and rotate it until it locks into place.
Figure 19. Frame Halves
SLOTS
PEGS
Figure 17. Frame Positioning
Figure 18. Frame Lockup
CAUTION! Position the front-to-rear
cable so it wont become pinched
between the frame halves when
pivoting the rear section forward.
