31
Victory XL-3
V I I . C O M F O R T A D J U S T M E N T S
ARMREST ANGLE ADJUSTMENT
There is an armrest adjustment dial on the underside of each armrest. To adjust the armrest angle upward or
downward while seated in your scooter:
n
Turn the armrest adjustment dial to the left to lower the armrest angle or to the right to raise the armrest
angle.
NOTE: The armrests also pivot upward to make getting on and off of your scooter easier.
LUMBAR SUPPORT ADJUSTMENT DIAL
The lumbar support is in the lower part of the seatback. To adjust the lumbar support, turn the adjustment
dial on the side of the scooter seat counterclockwise until you reach a comfortable position.
POSITIONING BELT
Your scooter seat may be equipped with an auto-type positioning belt that can be adjusted for operator
comfort. See figure 20. The positioning belt is designed to help support the operator so that he or she does
not slide down or forward in the seat. The positioning belt is not designed for use as a restraining device.
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom of the seat base. See figure 19.
3. Using a 5-mm hex key, remove the two bolts on the outermost part of the rear seat mounting strap.
4. Insert the bolt through the appropriate end of the positioning belt and then through the seat mounting
strap for each side of the scooter seat.
5. Tighten the bolts.
FIGURE 19. POSITIONING BELT INSTALLATION
SEAT MOUNTING STRAP
POSITIONING BELT
REMOVE BOLTS
REMOVE BOLTS
SEAT SLIDING LEVER
SEAT LOCK LEVER
FIGURE 20. POSITIONING BELT