Pride Jazzy 600 2S, Owner'S Manual

32

        www.pridemobility.com

                             Jazzy 600 Series

V I I .   C A R E   A N D   M A I N T E N A N C E

CARE AND MAINTENANCE

Your Jazzy 600 is a sophisticated power chair. Like any motorized vehicle, it requires routine maintenance checks.

You can perform some of these checks, but others require assistance from your authorized Pride Provider. Pre-

ventive maintenance is very important. If you follow the maintenance checks in this section as scheduled, you can

help ensure that your power chair gives you years of trouble-free operation. If you have any doubt as to your power

chair’s care or operation, contact your authorized Pride Provider. 

WARNING! Do not service the power chair when the seat is occupied.

Your power chair, like most electrical equipment, is susceptible to damage from the elements. Avoid damp areas

of any kind. 

WARNING! Direct or prolonged exposure to water or dampness could cause the

power chair to malfunction electronically and mechanically. Water can cause

electrical components to corrode and the chair's frame to rust. Power chairs should

be examined periodically for signs of corrosion caused by water exposure, bodily

fluid exposure, or incontinence. Damaged components should be replaced or treated

immediately.

Should your power chair come in contact with water:

1. Dry your power chair as thoroughly as possible with a towel.

2. Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.

3. Check the joystick operation and the brakes before using your power chair again.

4. If any inconsistencies are found, take your power chair to an authorized Pride Provider. Power chairs that are

frequently exposed to sources of water, such as incontinence, should be inspected often for corrosion and

electronic components may need to be replaced frequently.

Temperature

Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your

power chair between the temperatures of 18°F (-8°C) and 122°F (50°C).

In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze

depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., AGM

or Gel-Cell). 

Temperatures above 122°F (50°C) may cause your power chair to operate at a reduced speed. This reduced

speed is a safety feature built into the controller that helps prevent damage to the motor and other electrical

components.

General Guidelines

Avoid knocking or bumping the controller, especially the joystick.

Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.

Keep the controller clean.

Check all connectors to ensure that they are all tight and secured properly. 

   Make sure pneumatic tires are inflated to the psi/bar/kPa air pressure rating indicated on the tire. 

WARNING! Make sure your tires are inflated to the psi/bar/kPa air pressure raiting indicated on the

tire for pneumatic tires. Do not underinflate or overinflate your tires. Low pressure may result in

loss of control, and overinflated tires may burst. Overinflating tires can cause them to explode.

WARNING! Do not use a high pressure hose to inflate your tires.

Use a rubber conditioner on the tire sidewalls to help preserve them. 

WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the

tires slippery and cause your power chair to skid.