Jazzy Select 6
www.pridemobility.com
25
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position the controller for either left-
hand or right-hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See fig-
ure 13.
3. Slide the controller into or out of the armrest to the de-
sired position.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the joystick module from the connector on the
power base.
3. Cut the wire tie(s) that secure the joystick module cable
to the armrest and seat.
4. Flip up the armrest
5. Loosen the setscrew. See figure 13.
6. Slide the joystick module out of the armrest.
7. Loosen the setscrew in the other armrest.
Figure 13. Underside of Armrest
SETSCREW
8. Place the joystick module into the other armrest.
9. Tighten the setscrew to secure the joystick module.
10. Route the joystick module cable along the seat frame and secure with wire ties. See figure 10.
11. Plug the controller connector into the power base. See figure 6.
Manual Recline Seatback Adjustment
If your power chair is equipped with a manual recline seatback, you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of the seat base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or rearwards to the desired position.
3. Release the lever.
V . C O M F O R T A D J U S T M E N T S
