28
www.pridemobility.com
Jazzy Select 6
V . C O M F O R T A D J U S T M E N T S
To rotate the ELRs:
1. Push in release lever A.
2. Rotate the ELRs.
To adjust the ELR angle:
1. Push down release lever B.
2. Move the leg rest to the desired angle.
To adjust the ELR length:
1. Remove the two adjustment screws from the side of each leg rest extension.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws.
Positioning Belt
Your power chair may be equipped with a positioning belt
that can be adjusted for operator comfort. See figure 18.
The positioning belt is designed to support the operator so
that he/she does not slide down or forward in the seat. The
positioning belt is not designed for use as a restraining device.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to
the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through
the positioning belt and into the seat base for each side of
the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt
into the plastic housing on the opposite side until you hear
a click. See figure 18.
2. Pull the excess strap attached to the metal tab until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning
belt is properly secured to the power
chair and is adjusted for operator comfort
before each use.
MANDATORY! Inspect the positioning belt
for loose or damaged parts before each
use of the power chair. If you discover a
problem, contact your authorised Pride
Dealer for maintenance and repair.
Figure 18. Positioning Belt
