Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for fixtures.
Prima is not responsible for any fixture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult
our customer service department with any questions regarding dimmer specifics. Prima is not responsible for any damage caused by improper
dimmer specification and usage. Use only qualified electrician for installation. Adhere to all local and national electrical codes prior to installation.
It is strongly recommended that gloves are used when handling the FIT System track. Oils and dirt from fingers can sometimes permanently
mark the finish. Track should be cleaned with a damp cloth and thoroughly dried before fixture installation.Connectors are available for
extending track length, turning corners or creating intersections in the run. Great care must be taken to ensure the connector is installed
properly.
Q
FIT I System end top power feed 22-79224. Insert the connector into open end of a FIT I track length. Secure the powerfeed by tightening
the set screws with a flat head screwdriver at the top and bottom of the connector. Insert the transformer’s low voltage secondary leads
into the power entry connectors on the top of the powerfeed. Using the supplied hex wrench, secure the transformer leads by tightening the set
screws for each wire lead. Transformer low voltage leads must be 10 AWG THHN stranded.
end top power feed -
22-79224
two-way adjustable power feed -
22-79225
R
a
hinged construction which allows the two track lengths to be positioned at variable angles. Insert the connector into open end of a FIT I
track length. Secure the powerfeed by tightening the set screws with a flat head screwdriver at the top and bottom of the connector. Insert the
transformer’s low voltage secondary leads into the power entry connectors on the top of the powerfeed. Using the supplied hex wrench, secure the
transformer leads by tightening the set screws for each wire lead. Transformer low voltage leads must be 10 AWG THHN stranded. NOTE: Power is
end power feed -
22-79221, 22-79222, 22-79223
P
FIT I System end power feeds are available in three model which have powerfeed entry on the end (22-79221 shown in the example below)
the side (22-79222) or the top (22-79223). Insert the connector into open end of a FIT I track length. Secure the powerfeed by tightening the
set screws with a flat head screwdriver at the top and bottom of the connector. Insert the transformer’s low voltage secondary leads into the power
entry holes on the connector. Using the supplied hex wrench, secure the transformer leads by tightening two set screws for each wire lead.
Transformer low voltage leads must be 10 AWG THHN stranded.
Tighten screws
on both sides
Tighten
screws
on both
sides
Low voltage leads from
transformer. 10AWG THHN
stranded
Low voltage
leads from
transformer.
10AWG THHN
stranded
Low voltage
leads from
transformer.
10AWG THHN
stranded
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
REV
.033015
prima fit I system
general installation instructions part 9 of 12
NOTE: ALL POWERFEED WIRES FEED THROUGH OUR MOUNTING DISK #CO-036 OR J-BOX COVER PLATE #30-JBP.
SOLD SEPARATELY. SEE DIAGRAM ON PAGE PART 12 OF 12 FOR REFERENCE.
