fit I system support for horizontally oriented track
for cable suppport
Follow all local and national electrical codes.
For assistance please call Prima Customer Ser
vice at 562-407-3079
E
E1
E2
E3
E4
E5
E6
E7
IMPORTANT Please read these instructions prior to installation. Refer to the Prima catalog for proper lamp type and maximum wattage for fixtures.
Prima is not responsible for any fixture or system failure caused by unsupported lamps. Contact Prima customer service for the latest updates on
which lamps we support and proper usage. Prima low voltage transformers must be used with all Prima Lighting product installations. All warranties
are void if Prima transformers are not used. Prima’s catalogs provide general information and suggestions for proper dimmer usage. Please consult
our customer service department with any questions regarding dimmer specifics. Prima is not responsible for any damage caused by improper
dimmer specification and usage. Use only qualified electrician for installation. Adhere to all local and national electrical codes prior to installation.
It is strongly recommended that gloves are used when handling the FIT I track. Oils and dirt from fingers can sometimes permanently
mark the finish. Track should be cleaned with a damp cloth and thoroughly dried before fixture installation.
Be sure that the items indicated below are included in the package. Mount screw anchors in the mounting surface so that they align with
the holes in the mounting disk. Secure the mounting disk to the mounting surface with the included screws. Adjust the cable length by
loosening the set screw on the mounting disk, feed the cable through the top hole and tighten the set screw with the hex wrench. Further
adjustment may be necessary at the end of the installation process. Repeat the steps above for post installation adjustment.
Mounting disk
Hex wrench
Track bracket
Locking knob
Mounting screws
Anchors
If an installation consists of only a single run of FIT I System track mounted in horizontal orientation with cable suspension, it is recommended that
the same amount of track heads be placed in each of the track slots on both sides of the track. This is to balance the weight distribution between
the two track slots. If there is more weight on one side the track than the other, the track may lean to one side and appear out of balance. This
problem will not occur if the track is part of a multi-track length installation with 90º returns.
Insert the track into the
track bracket by resting
the one slot on the grip
teeth. Then twist the track
into position as shown.
This example shows a balanced
installation. The same amount of track
heads are installaed on each side of the
track. The track hangs in a level manner.
Balanced
Balanced
Unbalanced
Unbalanced
This example shows an unbalanced
installation. There is one track installed in
one of the track slots. As a result, the
track installation tends to lean to one side.
Secure the track with the locking knob. Insert the knob into the large hole on the side
of the track bracket. Rotate the track locking knob 90º clockwise to lock the track.
Secure the locking knob by tightening the inner knob until there is no slack and the
Further
adjustment
may be precise
lengths.
90º clockwise
Insert locking knob
Tighten inner knob
13615 Marquardt Ave. Santa Fe Springs, CA 90670
Ph. 562-407-3079 . Fx. 562-407-3069
www.primalighting.com
REV
.033015
prima fit I system
general installation instructions part 3 of 12
