ASSEMBLY cont.…
Please refer to the drawings on the previous page. Please not that the processor bowl lid must
be fitted correctly at all times before using the processor or blender.
1. Blender jug & processor bowl:
The blender jug sits on the locating pegs as shown in the
picture. The lid fits on top of the jug and must be turned clockwise to lock it into position.
Unless the blender jug is fitted properly, the motor will not run. The processor bowl ‘C’ also
sits on locating pegs as shown in the picture. This lid is fitted as shown then turned anti-
clockwise so that the interlock tag (C4) slots into the bowl lid locking slot (A4).
Important:
If
you are using the processor bowl only, remove the blender jug and close the safety lid (A1).
It is not good practice to run the machine with the blender jug empty. The maximum capacity
of the blender jug is 1.5 litres. The capacity of the processor bowl is 1.1 litres. Never exceed
the maximum fill level marked on the side of the blender or processor jugs.
2.
The
grating/slicing/chipping disks
(D2 & D5) must be attached to the spindle (D1) before
putting them over the shaft in the processor bowl. Note that the grating/slicing disk (D2) is
reversible but the chipping disk (D5) is not. When fitting the disk to the spindle push it in
firmly then turn the spindle slightly to lock it into place.
Take care when handling the disks
– the blades are very sharp.
Fit the lid as shown & use either the pulse settings or speed 1
for chipping or slicing, speed 2 for shredding. Always use the food pusher to gently force
food through the grating/slicing/chipping blades.
3.
To fit the metal chopping blade (E) slide it over the shaft in the processor bowl. Be sure to
remove the protective plastic sleeves from the blades first! As with the disks the blades on
this attachment are very sharp so please be extra careful when handling.
4.
The whisk stick (J) simply fits over the shaft in the food processor bowl.
5.
The twin beater is placed into the processor bowl. Ensure that the small metal peg aligns
with the hole in the lid.