GLASS JUG KETTLE MODEL: PGK200
Prior to First Use
•
Remove all packing materials from the inside and outside of the kettle.
•
BOIL FRESH WATER INSIDE THE KETTLE TWO TO THREE TIMES AND
DISCARD THE BOILED WATER BEFORE NORMAL USE
How to Use
•
Always use the appliance on a heat-resistant, flat surface
.
•
Fill the kettle with the desired quantity of cold water between the Min. and Max.
level.
•
Close the lid properly.
•
Plug the kettle into the wall socket and press the ‘ON/OFF’ switch to the ON
position. The power indicator on the base will then be illuminated.
•
When the water has boiled, the kettle will switch off automatically.
Cleaning
•
It is extremely important to remember that cleaning of the kettle can only be
performed when the plug has been removed from the supply.
•
Never immerse any part of the kettle especially the cable and base plate into
water.
•
Cleaning should be performed when the kettle has cooled down.
•
Always ensure the electrical connections of the kettle remain absolutely dry.
•
Clean the kettle with a damp cloth. Do not use cleaning products, which can
cause health hazard or discoloration of the kettle.
•
Ensure the outside and the electrical connection parts of the kettle are
completely dry before using.
De- scaling
•
It is important to de-scale the kettle at regular intervals in order to maintain its
looks and efficiency.
•
The frequency of de-scaling will depend upon the area in which you live
•
There are many de-scaling powders and tablets available in supermarkets &
hardware stores. Just follow the instructions on the packet. NOTE: The kettle
warranty does NOT cover faults caused by excessive limescale build-up.
Important Safety Notes
•
Always unplug the kettle in the following situations:-
-
Before
cleaning
-
After
use
-
Before
pouring
water
- Before leaving the kettle unattended
•
Do not unplug the kettle by pulling the cable cord.
•
Never place the kettle in a tilt position.
•
Keep the kettle out of reach of children.
•
Improper use of kettle may result in serious scald.
•
As there is boiling water inside the kettle, always put the lid on whenever
kettle is turned on or hot water is inside.
•
Never switch on the kettle when the water level inside is higher than the
indicated maximum level or lower than the minimum level. Otherwise, this will
cause water spillage and damage to the heating element respectively. Though
there is a cut-off device if the kettle overheats, allowing the unit to boil dry will
eventually damage the heating element.
•
Do not touch the exterior of the kettle, except the insulated handle as it will be
very hot.
•
Never place the kettle on a hot surface.
•
If the supply cord of this appliance is damaged, it must only be replaced by
Prima
•
The kettle is only to be used with the stand provided.
Summary of Contents for PGK200
Page 2: ......
