•
ALWAYS
thoroughly inspect the tree before installing your product.
DO NOT
install your
TREE/LADDER STAND
onto any dead or unsafe tree, telephone
or utility pole, structural column, or man-made structure. Doing so may result in serious injury or death.
•
ALWAYS
select the proper tree for use with your
TREE/LADDER STAND
. Select a live straight tree that fits within size limits recommended (minimum tree
diameter must be no less than 9 inches and maximum of 18 inches.).
DO NOT
rely on a branch for support.
•
DO NOT
select a tree in the dark or choose a tree in close proximity to a fence. You must not have any stumps or rocks beneath your tree.
•
NEVER
use
TREE/LADDER STAND
on a tree that is dead, diseased , leaning or on wet and uneven ground as the tree may fall, break or uproot.
• Your tree must not be wet, icy or slippery or on wet, swampy, or loose ground that allows the tree to be unstable. Check the ground under
TREE/LADDER
STAND
to ensure it is firm and level.
• Be sure you have a level stand platform. Your tree must not lean or have any irregular shape.
• Tree must not have any loose or scaly bark or excessive vines, nails, screws, or any other sharp objects protruding that may sever webbing on product. Any
surrounding trees must not lean or have dead limbs that may fall onto you or your product.
•
NEVER HURRY!!
HURRYING CAUSES ACCIDENTS!!
While climbing a
TREE/LADDER STAND
, make slow, even movements no more than ten to twelve
inches at a time. Make sure you have proper contact with tree and/or
TREE/LADDER STAND
every time you move. On ladder tree stand,
ALWAYS
maintain three points of contact with each step up the ladder and
ALWAYS
lean forward as you climb.
Several treestands are equipped with a footrest, armrests and/or shooting rail. Neither the footrest, armrests nor the shooting rail have been
designed to support a user’s weight. Under
NO
circumstances should you place more than fifteen (15) pounds of weight on these structures. Doing
so will put the user in serious risk of injury or death.
Choosing A Safe Tree
Proper Care And Maintenance:
Customer Service Department 1-866-972-6168
www.primaltreestands.com
• Inspection for defects (damage, rot, corrosion, cracks, freezing, excessive heat, etc.) before every use is required. Do not use if damage is
detected or suspected.
• We recommend replacing all hardware/cables/nuts/bolts/clips on your tree stand every two (2) years or sooner if inspection finds it necessary. Use
only Acheson Harriman Swan, LLC approved replacement straps and parts. Use of any other straps or parts, will be viewed as a modification to the
product. Any modification will void the warranties and relieve Acheson Harriman Swan, LLC from all liabilities. Failure to follow these instructions
may result in serious injury or death.
•
DO NOT
overtighten the hardware.
DO NOT
use a socket wrench. This can lead to structural damage and may negatively affect the performance
of your stand. Failure to follow these instructions may result in serious injury or death.
• All photos are taken from the front view unless otherwise noted.
• In most cases, bolts come with two nylon washers. One washer will be placed against the bolt head the other washer will be placed against the nut.
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
©2021 (rev. 1/21)
