Attachment Instructions
STEP 3:
Pull the excess of Tree
Strap to secure the stand to
the tree, as shown in
Fig. 3
. The
stand should be tight to the tree
as shown in
Fig. 1.
STEP 5:
When moving from your climbing aid
to your Hang-On Tree Stand, step down from
the aid to the stand
as shown in Fig. 5
.
Cautiously
put your weight on the stand's
platform. The additional weight will create
tension on the tree attachment strap and cables.
DO NOT LIFT THE FOOT PLATFORM WHILE THE STAND IS IN USE. LIFTING THE
FOOT PLATFORM COULD CAUSE YOUR STAND TO SHIFT, RESULTING IN SERIOUS
INJURY OR DEATH. YOU MUST ALSO WEAR A SAFETY HARNESS AT ALL TIMES
WHILE THE STAND IS IN USE, INCLUDING CLIMBING AND DESCENDING. FAILURE
TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH.
STEP 2:
With the treestand in the folded
position, wrap Tree Strap around the
tree once and hook the other end into the
tree strap Bracket . (
See Fig.1 and Fig.
2.)
Ensure that the strap is not twisted and is
laying flat against the tree.
This should be done beneath where your
climbing belt is attached to the tree so that
your climbing belt is above the treestand.
2
STEP 4:
Unfold the stand
by bringing the platform
downward
(See Fig.4).
Pull seat platform
downward and adjust seat.
4
3
5
CAUTIOUSLY
put your weight on the stand’s platform
The additional weight will create tension on the tree strap and cables.
W A R N I N G
FIG.5
FIG.1
STEP 1:
While wearing your
safety harness, connect your
climbing belt to the tree
following manufacturer’s
instructions. Climb to the
desired height using your
climbing aid. Once you have
reached the desired height,
hoist your treestand into
position.
1
FIG.2
FIG.3
FIG.4
Model: PVLS-211
Blackjack Steel Hang-On Stand
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
©2020 (rev. 1/20)
Customer Service Department 1-866-972-6168
www.primaltreestands.com
