PRIMAL TREESTANDS PVLS-316, Instruction And Safety Manual

Carefully tilt Handle Rail / Tree Brace / Ladder Jaw assembly

upward so that the Ladder Jaws      and      are towards the ground

and the ends of Handle Rails      are held upward. Slide the top 

ends of Top Ladder Section       into the downward facing ends of 

Handle Rails       .   Attach using 

2-M6x30mm bolts

NOTE

:

 Continue to leave Handle Rails      un-secured to the

Tree Brace       .

Slide Handle Rails      onto right and left front ends of

Tree Brace       assembly. 

NOTE

:

 Do not secure Handle

Rails        with bolts at this step.

ALL PHOTOS TAKEN FROM FRONT VIEW UNLESS OTHERWISE NOTED

Assembly Instructions Page 1

Remove all contents from packaging and make sure all parts are present before attempting to assemble.

Tighten all bolt connections by hand first and then when fully assembled, go back and tighten with a wrench.

3

1

2

3

center spacers located here

SIDE VIEW

Attach Left Ladder 

Jaw       and Right

Ladder Jaw       to Tree

Brace       using 

2-M8x90mm bolts 

with spacers

        on 

each side. 

1

2

Model: PVLS-316

17’ Single Vantage Deluxe Ladder Stand

Customer Service Department 1-866-972-6168

www.primaltreestands.com

Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO  80120

©2020 (rev. 1/20)