Firmly tighten Tree Buckle Strap (as shown
Fig. 1
). If buckle becomes
disassembled see
“Detailed Buckle and Strap Instructions”
Below. Test
for sturdiness before climbing.
Be sure to set stand where you are able to step
DOWN
onto stand platform from Fast Stick (See
Fig. 2
).
DO NOT
set stand above the top Fast Stick section. It will
create a dangerous situation when climbing in or out of
stand (See
Fig. 3
).
Check every Ladder Section for stability
BEFORE
you
leave the ground.
Wrap Tree Buckle Strap around the tree making sure that it is flat
against the tree. Attach the opposite open loop to the
strap attachment
point
on the rear of Ladder Section (as shown
Fig. 1
).
Installation Instructions
DETAILED BUCKLE AND STRAP INSTRUCTIONS
1
2
3
4
Pull strap to desired length.
Press down on latch and
insert strap underneath
teeth as shown.
Pull slack to tighten.
Hold buckle as shown.
Fig.1
Fig.2
Find an appropriate tree.
DO NOT
use on a leaning or dead tree. The tree should
have a diameter between 9 and 18 inches. Making sure that the center steps of the
stick ladder all angle upward, place the first of 3 stick ladder assemblies up to the
desired tree so that all of the tree braces are firmly against the tree. The stick ladder
MUST
be straight and vertical.
1
2
3
Strap Attachment Point
W A R N I N G
ALWAYS
use Fall Protection with this Ladder System. Make sure that your tether is
ALWAYS
mounted
ABOVE
you as you climb and install the ladder sections.
I M P O R T A N T
CORRECT
INCORRECT
Fig.3
Model: PVSL-125
Fast Stick 3-Piece Climbing Stick
Customer Service Department 1-866-972-6168
www.primaltreestands.com
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
©2020 (rev. 1/20)
While wearing your Fall Arrest System with Climbing Belt, Climb the bottom
section to attach the next section. The stick ladders should be spaced on the
tree to insure each step is no more than 18 inches apart.
Repeat steps 1
through 3 to attach all ladder sections.
4
