Distributed by Tahsin Industrial Corp. USA 685 Route 10 East, Randolph, NJ 07869
ASSEMBLY INSTRUCTIONS PAGE 3
MODEL: WMCS-400
ALUMINUM CLIMBER
C
M
Have both top and bottom platforms
angled down towards base of tree
to compensate for a smaller tree
diameter at desired hunting height.
At ground level, apply pressure to both platforms to ensure they
have appropriate angle on tree and T-knobs are properly installed.
NOTE:
Images used are for demonstration purposes only and may not depict the actual product.
11. Tie Rope
N
to Seat Platform
A
at the rear support and the other end to
Foot Platform
B
at the rear support.
DO
NOT
tie around the teeth.
12. At ground level, step cautiously onto the foot platform. Attach your harness to the tree
(as
per harness manufacturer’s instructions).
Standing on the foot platform facing the tree, insert your feet into foot straps. Tighten foot straps
as needed. Secure bungee strap around your heels to assist in keeping feet in foot straps.
Raise Seat Platform to about chest height. The rope is used to secure both platforms together
so the platforms will not fall away accidentally while climbing.
10. Wrap the cable around the back of the tree and insert
the other end of Cable
C
into the opposite railing of the
Foot Platform. Secure with
1-M12 Quickclip
M
. Install the
Seat Platform above Foot Platform in same fashion and at
identical angle.
B
A
C
M
N
N
©2013 (rev. 12/12)
CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
WWW.TREESTANDCUSTOMERSERVICE.COM
