CUSTOMER SERVICE DEPARTMENT 1-866-972-6168
Distributed by Primal Vantage Company Inc. 150 Morristown Rd. Bernardsville, NJ 07924
A
B
V
MAKE SURE ALL BOLTS ARE
TIGHT BEFORE PROCEEDING TO
INSTALLATION
W
X
Attach Ratchet Strap
X
to the tree brace as shown
above.
(See Ratchet Instructions for weaving)
Attach Installation Straps
W
just behind the attached
Ratchet Straps, as shown above.
(See Installation Strap Instructions for weaving).
•
ALWAYS
thoroughly inspect the tree before installing your product.
DO NOT
install your
LADDER STAND
onto any dead or unsafe tree, telephone or utility
pole, structural column, or man-made structure. Doing so may result in serious injury or death.
•
ALWAYS
select the proper tree for use with your
LADDER STAND
. Select a live straight tree that fits within size limits recommended (minimum tree diameter
must be no less than 9 inches and maximum of 18 inches.).
DO NOT
rely on a branch for support.
•
DO NOT
select a tree in the dark or choose a tree in close proximity to a fence. You must not have any stumps or rocks beneath your tree.
•
NEVER
use
LADDER STAND
on a tree that is dead, diseased , leaning or on wet and uneven ground as the tree may fall, break or uproot.
• Your tree must not be wet, icy or slippery or on wet, swampy, or loose ground that allows the tree to be unstable. Check the ground under
LADDER STAND
to
ensure it is firm and level.
• Be sure you have a level stand platform. Your tree must not lean or have any irregular shape.
• Tree must not have any loose or scaly bark or excessive vines, nails, screws, or any other sharp objects protruding that may sever webbing on product. Any
surrounding trees must not lean or have dead limbs that may fall onto you or your product.
•
NEVER HURRY!!
HURRYING CAUSES ACCIDENTS!!
While climbing a
LADDER STAND
, make slow, even movements no more that ten to twelve inches at
a time. Make sure you have proper contact with tree and/or
LADDER STAND
every time you move. On ladder tree stand,
ALWAYS
maintain three points of
contact with each step and
ALWAYS
lean forward as you climb.
.
Several treestands are equipped with a footrest, armrests and/or shooting rail. Neither the footrest, armrests nor the shooting rail
have been designed to support a user’s weight. Under
NO
circumstances should you place more than fifteen (15) pounds of weight
on these structures. Doing so will put the user in serious risk of injury or death.
Insert sleeved end of Middle Ladder Section
B
into the straight end of Ladder Section
A
.
Insert
1-Quickclip
V
through the hole on the
sleeve and through the ladder sections on
each side of the ladder. Close the quickclip to
secure the ladder sections together. Repeat
for Bottom Ladder Section
S
.
©2017 (rev. 12/16)
ASSEMBLY INSTRUCTIONS PAGE 4
MODEL: PVLS-315
DELUXE LADDERSTAND
CHOOSING A SAFETY TREE
10
11
10
11
W A R N I N G
REAR VIEW
WWW.PRIMALVANTAGE.COM
