DD
BB
Z
Y
NOTE:
The Ladder Jaws are designed to wrap around
a tree trunk when Vertical Jaw Assembly Strap is
tightened (shown left).
Before engaging the Ladder Jaw Mechanism:
1) Check that the Ladder stand is properly installed on
correct sized tree. If the ladder jaws cannot close
on the tree trunk (pictured top left), the tree is too
large for safe installation.
2) Check that the installation straps are correctly
wrapped around the tree base and tightly secured
3) The Truss Mechanism is properly tensioned.
4) The ladder base is correctly and safely secured onto
level ground.
Check to make sure the Vertical Jaw
Assembly Strap is not caught, tangled
or snagged. Make sure the strap falls flat
and straight from the foot platform.
Carefully loop the Vertical Jaw Assembly
Strap through either the right or left metal
hooks on the Truss Bar (as shown left).
Lightly pull on Vertical Jaw Assembly strap
to and check to make sure that both
ladder jaws close in on the tree trunk.
Loop Jaw Assembly Tree Buckle
through Jaw Assembly Ratchet Strap
.
With the Jaw Assembly Ratchet Strap
attached, wrap the Jaw Assembly
Tree Buckle around tree trunk at
a lower diagonal point from the Truss
Bar (as shown right). Feed Jaw
Assembly Tree Buckle Webbing
though the spring loaded cam buckle
and firmly tighten around tree trunk.
Position Jaw Assembly Ratchet Strap
so that it faces the ladder. Feed
Vertical Jaw Assembly Webbing
through ratchet strap and ratchet the
strap tight until the tension closes the
ladder jaws.
DO NOT overtighten
.
See “Ratchet Strap Instruction” for
correct operation of the Ratchet Strap.
6
7
8
Installation Instructions Page 2
NOTE: Ladder should arc slightly
outward even after Jaw Assembly
Strap Webbing is fully tightened
2019
©2019 (rev. 1/19)
Customer Service Department 1-866-972-6168
www.primaltreestands.com
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Z
U
U
Z
Z
Z
Y
Z
Z
U
DD
Model: PVLS-600
Single Vantage 17’ Xtra Wide Deluxe Ladderstand
