SINGLE VANTAGE 17’ DELUXE LADDERSTAND
1
2
3
4
5
6
9
Open ratchet handle
flat and insert end of
strap through opening
Pull Strap through
opening
Insert end of strap
through slot in ratchet
wheel
Ratchet handle back
and forth to tighten
strap
To release tension, push
spring loaded retaining lock
and simultaneously pull
on strap
After strap is tight,
close handle to
the locked position
W A R N I N G
Installation Straps, Truss and Ladder Jaw Assembly MUST
be secured and engaged prior climbing the Ladder Stand.
Failure to comply may result in serious injury or death.
After the ladder stand has been secured to the tree
with:
1) The installation straps secured.
2) The truss cable correctly tensioned
3) The Ladder Jaw system fully connected/engaged.
4) The Ladder securely attached to the tree.
Continue to have two people hold the ladder, climb
cautiously up to the platform. Once you reach the
top,
IMMEDIATELY ATTACH YOUR SAFETY HARNESS
TO THE TREE.
Keep the tether strap above your head.
9
Before sitting down, IMMEDIATELY locate Ratchet Strap at
the tree brace, behind the seat backrest. Wrap the strap around
the back of the tree once, thread through the ratchet and tighten
(See side view:
10a
and cross-section:
10b
).
(See Detailed
Ratchet Instructions below for proper use).
10
Detailed Ratchet Strap Instructions
DO NOT
sit on the seat platform until the ratchet has been secured.
W A R N I N G
Installation Instructions Page 3
NOTE:
Drawings are for illustration purposes only and may not depict actual product.
10a
10b
LADDER
STAND
TOP
2019
©2019 (rev. 1/19)
Customer Service Department 1-866-972-6168
www.primaltreestands.com
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Y
AA
AA
AA
Model: PVLS-600
Single Vantage 17’ Xtra Wide Deluxe Ladderstand
