Slide Handle Rails onto right and left
front ends of Tree Brace assembly.
NOTE
:
Do not secure Handle Rails
with bolts at this step.
ALL PHOTOS TAKEN FROM FRONT VIEW UNLESS OTHERWISE NOTED
Assembly Instructions Page 1
Model: PVLS-600
Single Vantage 17’ Xtra Wide Deluxe Ladderstand
Remove all contents from packaging and make sure all parts are present before attempting to assemble.
Tighten all bolt connections by hand first and then when fully assembled, go back and tighten with a wrench.
1
2
3
center spacers located here
SIDE VIEW
4
2
Carefully tilt Handle Rail / Tree Brace / Ladder
Jaw assembly upward so that the Ladder
Jaws and are towards the ground and
the ends of Ladder Yokes are held upward.
Slide the top ends of Top Ladder Section
into the downward facing ends of Ladder
Yokes . Attach using
2-M6x30mm bolts
NOTE
:
Continue to leave Handle Rails
un-secured to the Tree Brace .
4
Attach Left Ladder
Jaw and Right
Ladder Jaw to Tree
Brace using
2-M8x90mm bolts
with spacers
on
each side.
1
Attach left and right Ladder
Yokes onto each handle
rail using
2-M6x30mm bolts
3
2019
©2019 (rev. 1/19)
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
www.primaltreestands.com
K
K
K
L
L
L
K
L
H
H
H
H
J
A
A
J
J
H
F
J
F
F
H
H
F
J
J
L
K
