Lay the two Foot Platforms side by side
(grate side down). Place the Platform Truss
Loop over the front set of holes on the front
side of the platform. It should be at a 90° angle
from the platform so it points to the ground.
Fasten the Foot Platforms together using
3-M8x55mm bolts .
5
E
FF
55
55
2019
©2019 (rev. 1/19)
7
With the Handle Rails/Tree Brace/Ladder Jaw
assembly in the same position from
Step 3
,
secure Backrest Supports through right
and left Handle Rails and Tree Brace
(already slid inside of Handle Rail tubes) using
2-M8x60mm bolts . NOTE
:
There are 2
sets of holes in the Backrest Supports .
Use the lower holes to attach the Handle
Rails . The top holes will be used to
attach the Seat
Couple together Left and Right Backrest
Support and secure them together using
1-M6x35mm bolt .
Attach Backrest
Support to the rear of Foot Platform
using
2-M8x55mm bolts . NOTE
:
The top
of Left and Right Backrest supports should
bend AWAY from foot platform as shown.
Assembly Instructions Page 2
6
7
Attach Foot Platform and Foot Rest to
Ladder Yokes using
2-M8x70mm bolts
with 3 washers
.
NOTE: Center washer
should go in between Foot Platform
and Foot Rest on both sides.
8
5
6
8
Customer Service Department 1-866-972-6168
www.primaltreestands.com
Distributed by Primal Vantage Company Inc., 2407 W. Euclid Ave., Littleton, CO 80120
E
E
E
H
H
H
E
E
E
E
M
M
M
M
M
F
F
J
O
O
O
M
M
M
FF
55
FRONT
Model: PVLS-600
Single Vantage 17’ Xtra Wide Deluxe Ladderstand
55
55
35
35
