P r i m a L u c e L a b i S r l
S p i d e r 2 3 0 u s e r m a n u a l
Now take the support device for equatorial
mounts (
2
) of the parabolic antenna. It’s already
preassembled with the connecting plate for the
antenna. Unscrew the two screws on the bot-
tom plate by removing the end of the bar. Now
insert, by sliding from the lower part of the plate
one of the 2 5Kg counterweights for Declination
axis (
4
) and secure it at the bottom of the plate
by tightening the two locking screws (make sure
it does not move). Then screw the back plate at
the end of bar.
!
!
!
!
!
Then place the support device for equatorial mounts (
2
) onto the upper part of mount head (
13
) and close the 2
knobs lock on the side. Make sure that the plate is tight and does not move. Insert the 4 M6x55 screws (
28
) in the
front disc and attach by screwing, as in the image below, the 4 spacers (
11
- one for each screw). The spacers have
a variable thickness with a side less thick: this goes toward the center of the support disc (in fact it fits to the shape
of the parabolic reflector). Do not tighten all the screws of the spacers but leave slightly open to allow you to move
the screw along the slot of the circular plate (used to attach the plate to the antenna more easily).
!
!
!
!
!
!
p a g e
!
1 6
Less thick side
More thick side
M6x55 screws