P r i m a L u c e L a b i S r l
S p i d e r 2 3 0 u s e r m a n u a l
To adjust the position of the 4 just inserted screws (to fix the spacers) sliding them in the slot, you can help by in-
serting the front support disk (
10
) and slide the screws until they pass through the holes of the disc itself. Then
remove the front support disk.
!
Now proceed with the parabolic reflector installation. This procedure must be done at least by 2 people but, for
simplicity, we recommend that you run it in 3. Lift carefully the entire reflector and, making sure not to damage the
parable itself, place it right in front of 4 spacers (
11
) that you have previously installed. Match the 4 central holes
(90° apart) with the 4 screws and pull down until the reflector touches the 4 spacers.
Due to the large size of the
parabolic antenna, this step may be difficult: execute it carefully helping the insertion of the reflector impressing
small vibrations.
!
!
!
!
p a g e
!
1 7
Front support
disk
Parabolic antenna holes for
screws insertion