P r i m a L u c e L a b i S r l
S p i d e r 2 3 0 u s e r m a n u a l
Then take the 4 support plates: 3 of these have 4 holes (
7
) and one has 3 holes (
8
). The plates must be fixed on the
edge of the reflector, in correspondence of the pairs of holes (there are 4 pairs of holes spaced 10 cm), using for
each hole a M6x30 screw with two washers and one nut (
26
). The smaller plate (
8
) is inserted into the holes in
correspondence with mount counterweights bar.
!
!
p a g e
!
1 9
The plate with 3 holes
has to be installed on
the holes in corre-
spondence with
mount counter-
weights bar
Fasten the plates with
2 M6x30 screws,
fixing it to the
reflector with the nut
provided