P r i m a L u c e L a b i S r l
S p i d e r 2 3 0 u s e r m a n u a l
Now take the 3 rear tie rods (
6
): two are 1422mm long and one is 1453mm long. The longer rod must be screwed
into the threaded pin pointing in the opposite direction of the counterweights bar, just above the support device for
equatorial mounts. The two short rods instead should be placed laterally (one to the left and one to the right than
the first). To correctly insert the rod, place one end close to the corresponding plate (which we installed on the re-
flector) and the other end on the threaded screw of tie rods supporting block.
!
!
Then tighten until the end of the rod toward the plate pass within the plate itself. Take a M6x16 screw with washer
(
27
) and, by entering one for each plate, screw it on each of the 3 rods.
!
!
p a g e
!
2 0
1422mm
tie rod
1453mm
tie rod
Securing screw
of tie rod on the
plate
1422mm
tie rod