Eureka3 User Manual
Eureka3
Page 28
5.5.1 Pipe Length
Tap the value above the pipe section to edit the pipe section length; this will display a numeric
keyboard on the screen. Enter the length and tap the return key; the cursor will move to the Pipe
Diameter field. Now enter data for the diameter or tap off the keyboard to cancel further data entry.
There is no minimum pipe section length; the maximum is 2500metres.
5.5.2 Pipe Diameter
Tap the value to the left of the pipe section to enter the nominal diameter; this will display a numeric
keyboard on the screen. Enter the diameter and tap the return key to confirm the diameter data. The
minimum pipe diameter is 8mm and the maximum is 2000mm.
5.5.3 Pipe Material Type
Tap on the pipe section to change the type of material; this will list the types of pipe material available;
tap to select the appropriate material.
5.5.4 Add Pipe Section
To add a pipe section, tap on either the red or blue + sign at the end of the pipe model. A new section
will be created with default length, diameter and material. These can be changed using the actions
above. Up to six sections of pipe can make up the pipe model.
5.5.5 Remove Pipe Section
To remove a section of pipe tap on the X button toward the top right of the section; this section will
then be removed from the model. A pipe model must consist of at least one section of pipe, so it is not
possible to remove the last remaining section.
5.5.6 Tick Button
Tap this button to confirm the changes to the pipe model and return to the correlation screen. Any
previous correlation graph displayed will be cleared.
5.5.7 Cross Button
Tap this button to abandon any changes and return to the correlation screen.
