KidWalk
II
Owner’s Manual
11
MEASUREMENTS & INITIAL SETUP
Measurements:
The following measurements should be taken
and recorded to properly setup
KidWalk
II
:
Inside Leg
__________
Hip Width
__________
Chest Width
__________
Thoracic Height*
__________
Head Height*
__________
*Thoracic height and head height measurements should
be taken from the top of the inside leg. These
dimensions are needed to setup
KidWalk II
optional
Lateral Chest System and/or Headpad and Headrests.
KidWalk
II
Initial Adjustments:
Seat Height
Using the Height Adjust / Release Handle or the
Fine Adjustment Handle (fig. 9), adjust the seat
height to about 1” higher than the inside leg
measurement.
To raise the seat
assembly with the Height Adjust /
Release Handle, press down on the top of the mast
while lifting up on the Height Adjust / Release Handle.
To raise the seat
using the Fine Adjustment, place
your hand in the handle and squeeze the Lower
Fine Tune handle (fig. 9). Each time you fully
activate the Fine Tune handle the seat will rise up
approximately 12 mm.
To lower the seat,
lift up on the T-handle to
release any weight from the seat assembly and
press slightly downward on the Height Adjust/
Release Handle (fig. 9). Only minimal pressure is
needed to lower the seat down the mast.
Do not
push too hard.
Releasing the Height Adjust/
Release Handle will stop the seat from lowering.
For safety reasons,
KidWalk
II
seat
height cannot be lowered while there is
weight on the seat.
Other Items:
Make sure that all of the Support pads are high enough
and opened wide enough to allow the client to initially
easily fit within them. Adjust any optional items per the
instructions included with the item.
Height Adjust /
Release Handle
Fine Tune
Adjustment Handle
Fig. 9
T-Handle
Note: Never leave a client unattended while using the
KidWalk
II
.
Fig. 10
Entry Position:
