Prime Security PrimeStart 450, Owner'S Manual

User-Programmable Features

All PrimeStart system and remote control programmable features are

accomplished by turning the ignition key on (or starting the engine) and

flicking the valet switch on and off a preset number of times. 
The PrimeStart also allows you to add new remote controls in one step, delete

lost or stolen remote controls or rearrange the factory preset remote control

functions.

1. Remove the system from Protected Valet Mode. Programming cannot be

accessed while the system is in Protected Valet Mode indicated by the LED 

on solid red.

2. Select the feature you wish to program from the "Programming Table for

System Features"  or the "Programming Table for Remote Controls" on 

pages 11 and 12.

Note the number of beeps associated with that feature.

3. Turn the ignition key to the "ON" position.

4. Within 10 seconds, begin flicking the valet switch on and off. The built-in

piezo beeper will beep once each time you flick the switch on then off. 

5. Continue flicking the switch on and off, counting the number of beeps.

NOTE:  Stop when you reach the number of beeps associated with

your chosen feature.

6. Follow the "Secondary Action." You will hear a number of beeps to

confirm that you have changed the setting of that feature.

7. Turn the ignition key to the "OFF" position.

8. Repeat steps 1-7 for any other feature you wish to program.

10

PrimeStart 450 Owner’s Manual