Prime Security PrimeStart 650, Installation Manual

Factory Alarm Disarm (-) Output
The GRAY/WHITE wire will provide a 0.75 second ground output when the
START button is pressed.
1. Arm the vehicle factory alarm system.

2. Use a volt/ohmmeter to locate the one wire that will show ground only

when the driver door key cylinder is held in the unlock position.
NOTE: most factory alarm disarm wires will show 8-12 volts while
armed. A few vehicle disarm wires will rest at a neutral state while
armed. Regardless of type, both types will change to ground when the
key cylinder is turned to unlock.

3. Connect the GRAY/WHITE wire to the factory alarm disarm wire.

Accessory Remote Start (-) Input
The BLUE/ORANGE wire will accept a (-) input pulse to activate the
remote start.

Trunk Switch
1. Locate the vehicle trunk switch that shows ground when the trunk is

open only.

2. Connect the alarm module TAN/BLACK wire to the vehicle trunk switch

wire.

3. If the vehicle does not have a trunk switch, install a pin switch and

connect it to the alarm module TAN/BLACK wire.

Ignition Switch Connections
NOTE: Because these wires can draw high current, we recommend that they
be soldered and shrink tubed or taped. If only one PINK wire is needed, tape
the end of the second PINK wire to prevent a short circuit. The main control
module has an 18 ga PINK wire that must be connected to the vehicle
ignition wire with one of the satellite module 14 ga wires.

Ignition #1 Ignition #2
The satellite relay module has two onboard 30-amp relays. Most vehicles have 
only one ignition wire necessary to start the vehicle. Some vehicles have two
ignition wires. Make all wire connections at the ignition switch wire harness.

(Con tin ued on next page)

12

PrimeStart 650 Installation Manual