INSTRUCTION MANUAL
First read the manual carefully before you start using the safe.
Preparation for use (open the door with override key and installing the batteries):
This product is battery operated. Batteries are supplied. Only use 1.5V AA batteries. For your convenience, we have
engineered a manual override system for your safe. To open the door of the safe for the first time, just remove the
override cover plate (a)(see diagram 1). You will find the keyhole, insert the key into the keyhole and turn, turn the
knob (b) (see diagram 1) in a clockwise direction. Open the safe, to install the batteries, find the battery
compartment
(c) (see diagram 2).Ensure the + and – positions are correct. The display (d) (see diagram 1) will
scan the status of the electronic system automatically. If it is in order the display will show "good".
Open the safe :
To open the door of the safe, press the button "START"(e)(see diagram 1), the display on the panel will show"-----",
then input one of the two sets of factory-preset codes: 0.0.0.0(user code) or 8.8.8.8(master code) immediately and
confirm by pressing the button "START" again. The display shows "OPEN" and turn the knob within 5 seconds to
open the safe. If you do not want the display to show your codes when you open the safe, just press the button
"START" twice at the first time of pressing and other steps remain same.
Programming the code
:
The safe can be programmed with two sets of codes. For your safety, after opening the safe and installing the
batteries, you should program two sets of your new codes to take place of two sets of factory-preset codes.
