24
Chapter 3 Standard Operations
3.2 Turning On the Server
1
Open the rack door.
"3.1 Opening the Rack Door" (pg.22)
2
Power on the display and peripheral devices.
3
Press the main power switch on the front of the chassis.
Press the switch until the main power
supply LED of the chassis turns green.
Pressing this switch starts the system fan unit and the Switch Blades. It takes about one
minute for the Switch Blades to become fully operational.
Power will be distributed to the server blade but the server blade will not be activated until
its power is turned on.
• Do not move, strike, or shake the server when it is turned on. Doing so may damage the hard
disk and cause data to be lost.
• Turn the server on when the temperature is in its operating environment range (10-35
°
C). For
details about the operating environment, refer to "Start Guide" and "Safety Precautions".
When operating the device outside of this operating environment, the server may operate
improperly, damage data etc.
When operating the device outside of this operating environment, Fujitsu cannot be held
responsible for any related damage, malfunction, or loss of data, etc.
• The fans rotate at high speed immediately after the power of the chassis is turned on, but this
is not defective.
When the temperature is within the server's operating environment range (10-35
°
C), they will
start to rotate at normal speed later.
• Do not turn on the main power supply of the chassis until at least 2 minutes has passed since
the power supply cable was plugged in.
• Be sure to wait for 10 seconds or longer after shutdown of the main power supply of the
chassis or the server blade before turning the server on.
Main power LED
is lit in green
Main power switch
