13
PRIMERGY BX600 S2 Blade Server System Unit Hardware Guide
1
C
o
mpon
ent N
a
mes a
nd
F
u
nctions
16 17
13
33
34
20
21
DC
AC
FAN
26
23
22
6
7
8
27
28
32
31
30
29
25
24
10 11 12
14
15
[When options are installed]
18
19
*: For device options not shown in this manual,
refer to the “PRIMERGY ServerBooks” supplied with the server,
and the “Supplement” supplied with each option.
10
11
Fibre Channel error LED
Fibre Channel link LED
FC Pass-Thru Blade (option) LED. The error and link
LEDs light/blink depending on the status of the server.
LED status
Server Status
Link LED Error LED
OFF
OFF
A Fibre Channel Expansion
Board is not installed in the server
blade of the target connector or
the power of the server blade is
off.
ON
(Green)
ON
(Amber)
A Fibre Channel Expansion
Board is installed in the server
blade of the target connector and
the power of the server blade is
on.
ON
(Green)
OFF
The fibre channel card in the
server blade of the target
connector is online.
OFF
ON
(Amber)
The fibre channel card in the
server blade of the target
connector is offline.
OFF
Blinking
(Amber)
A link has not been established
with the external fibre channel
device.
Blinking
(Green)
Blinking
(Amber)
There is an error in the Fibre
Channel Expansion Board
installed in the server blade of the
target connector or the FC Pass-
Thru Blade. Contact an office
listed in the "Contact
Information" of "Start Guide" or
device administrator.
12
Fibre Channel connector
Install the optional SFP module (For users using 2Gbit/s
FC I/O Module (PG-FCD101) the SFP module is
supplied with the expansion board.) and connect to the
fibre channel device.
13
1000BASE-T connector
This is the external connection LAN connector of the
GbE Pass-Thru Blade (option).
14
LAN active LED
It blinks depending on the LAN transfer status of the
GbE Pass-Thru Blade as follows.
15
LAN link LED
It lights up depending on the LAN connection status of
the GbE Pass-Thru Blade as follows.
16
Switch Blade maintenance LED
It is possible to make the LED blink (amber) by using a
Switch Blade identification function. Refer to "BX600
Management Blade Hardware Guide".
17
10/100/1000BASE-T connector
This is a Switch Blade (option) LAN connector.
LED status
Server Status
Blinking (Amber)
Data is being transferred
LED status
Server Status
ON (Green)
LAN link is being established