51
PRIMERGY BX600 S2 Blade Server System Unit Hardware Guide
4
Inst
a
llin
g O
p
tio
n
s
4
Remove the dummy PSU.
Remove the dummy PSU using both hands.
Be sure to keep the removed dummy PSU for
later use.
5
Install the PSU.
1. Check that the handle of the PSU is
lowered. If not, pull it down.
2. Using both hands, insert the PSU into
the PSU slot (1) and pull up the handle
(2).
When installing a PSU, check that the connector pins at the rear of the PSU are not
damaged or bent.
Check that PSU is inserted firmly to the back of the PSU slot.
6
Connect the power supply cable to the PSU.
→
"Start Guide"
■
How to remove a PSU
To remove, simply reverse the installation procedure in "
Do not operate when the PSU or dummy PSU has been removed.
1
2
