6
CAUTION !
The first time you press the iron's microswitch to flow steam you may have a steam
liquidation
,
due to the cold condition of the iron's steam hose.So please press 2-3
times the microswitch away from the working surface until only clean dry steam
flows out.
Before you start working, make sure that the water feeding vessel of the machine,
is filled.
In case the pump runs unusually noisily for quite long period of time, the
feedwater tank may be empty or the filling hose may be clogged.
Switch off the iron buttons No 07.
Turn off the main switch No 02
Turn on slowly the outlet valve No 09 to remove the water deposited in the boiler.
WARNING !
To avoid any burning accident ,follow carefully the instructions below:
Fill the condensate vessel C(sketched below) by water,at a level of 5 cm.approxima-
tely. Screw tightly cap D.Unlock safety blocker A.Turn on slowly the outlet valve B to
remove any water condensates from the boiler. After finishing, turn off outlet valve B
and lock again safety blocker A.
C
Remove a small quantity of water (0,5lit.approx.) of the boiler, by turning on slowly
the outlet valve No 09.The pump is activated automatically in order to feed the boiler
by the lost quantity of water. When the pump stops, turn off outlet valve No 09.Wait
for a few minutes .When the manometer No 06 reaches 3,5 bars, the machine is ready
to work.This procedure must be periodically repeated.
After you finishing working
Test the good operation of the machine
