PROGRAMMING MANUAL
PUB. DATE 11/02
505 556
6
Choose the desired
language :
You can choose from offered languages by „
A
“ and „
E
“. Confirm by „
I
“ key. Then the display reads:
Language selected
System restart ...
In case that a selected language is not installed in your machine, the display will read:
This language is
NOT available
You can ask your supplier for the required language installation.
PROGRAMME EDITING
When pressing „
E
“ key after the previous „
Change The Active Language (Y/N):
“, the display will read a
question:
Number of the recipe
you want to edit:
By using „
A
“ and „
E
“ keys, choose a programme number and confirm by „
I
“ key. You will be asked to set
individual parameters of the program step by step, see fig. 3.4.B.
1. Required temperature value in range 10 – 180°C:
Input: [ degrees C ]
Temperature:
According to linen materials, the following temperature setting is recommended:
TEMPERATURE (°C)
MATERIAL
80
Polyacryl, Polyamid
105
Polyester, Cellulose
130
Silk
165
Wool, Cotton
170
Flax
Tab. 3.4.A
2. Speed value in range 150 – 800 cm/min:
Input: [ cm/min ]
Machine speed:
The machine executes automatic correction of the speed according to temperature changes. If temperature
decreases, the motion of the roller slows down to achieve quality ironing and to prevent temperature decrease.
If, on contrary, temperature increases, then motion of the roller speeds up. For this reason the speed value
on display in the operation mode will be mostly different than preprogrammed value.
3. Value of the fold length in range 25 – 50 cm:
Input: [ cm ]
Fold length:
Enter zero fold length for the folding mode with the constant number of folds or without folding. When enter
nonzero value, it means folding mode with the constant fold width, the parameters 4 and 5 will be skipped.
4. Number of folds in range 0 – 9:
Number of parts:
Enter zero number of folds for the mode without folding, in this case all following parameters will be skipped.
5. Value of the linen length in range 50 – 999 cm:
Input: [ cm ]
Length of linen:
Following parameters of the program will be displayed only when the cross folder or stacker are connected:
6. Number of cross folds in range 1 – 3:
[ ]
Cross folds (0-3):
When enter the value less than 3, the following parameter will be skipped.
