5
3
2
6
7
1. Fill up with water. Put the lid on. Place the stove on a stable/flat
surface.
2. Use the extra support if necessary.
1. If the problem is not fixed by following these instructions, return the
gas appliance to the closest Primus retailer.
2. Never attempt any maintenance or repairs other than those
detailed in these instructions.
3. Never make any alterations to the gas appliance, as it may then
become dangerous to use.
1. Only use genuine Primus spare parts and accessories.
Take care when assembling spare parts and accessories, and avoid
touching hot parts.
2. Replacement cartridge: This appliance is only intended for use
with the Primus Propane/Butane mix cartridge 2206.
3. Spare parts
734790
Jet nipple 0.23 mm
732440
O-ring
737650
Piezo igniter
4. If you have difficulty in obtaining spare parts or accessories, contact
your local Primus distributor or go to www.primus.se
1. Once the stove has cooled down, disassemble it and place the
burner and gas cartridge in the pot.
2. If the stove is to be stored away for a longer period, make sure that
all the parts are clean and dry. Always disassemble the burner and
gas cartridge when packing away the stove! Keep the cartridge in
a dry, secure place, where there are no heat sources. Avoid direct
sunlight.
1. If for some reason the gas pressure falls or it is not possible to light
it, check that there is gas left in the cartridge (7.2).
If there is, make
sure that the nozzle (7.5) is not blocked.
CLEANING THE NOZZLE
2. Close the burner valve completely (7.1) and unscrew the gas
cartridge (7.2). (
3. Unscrew the burner (7.3) from the valve (7.4).
4. Unscrew the nozzle (7.5) using a 6 mm open-ended spanner.
5. Blow in the small hole at the end to clear the nozzle. Do not use
a needle or similar object to clean the nozzle, as this could damage
the hole and make the gas appliance dangerous to use.
6. Put the nozzle back and attach it tightly. Reattach the gas cartridge by
following the instructions in item 4. For extra safety, check the
sealing joint with soapy water. If you see bubbles, the joint is not
sealed tightly enough.
7. Place the burner on the valve and secure it with the two smaller
screws (7.6).
FILLING THE POT
MOUNTING THE POT
AFTER USE
MAINTENANCE
SERVICE AND REPAIRS
SPARE PARTS AND ACCESSORIES
Use of other pot or pan:
Eta Lite is intended for use with the accompanying 1.0 litre pot.
In an emergency, other pots can be used by screwing in the
three supplied plugs from the top.
NEVER
PLACE A REGULAR
POT DIRECTLY ON THE BURNER WITHOUT USING THE PLUGS.
(fig 8).
1. Fit the bottom of the pot to the burner and turn the pot clockwise
until it stops (seen from above, around 45 degrees in relation to the
burner).
2. Hold the plastic grips on the burner and pot respectively when you
turn it.
USEFUL TIP!
Place the stove out of the wind, if possible, for a more efficient use of
fuel. This means shorter cooking times and a lower fuel consumption.
Do not light the stove with a dry pot. Turn the opening of the lid
to face away from the burner valve of the stove.
