755-503revB
7
Printed in USA 12/06 © 2006
Timers
755 Series
Individual Channel Programming (Single Display Timers)
Timer Programming
1
To program the timer, all four or ten timing channels must be idle with the
display showing either one or three sets of four dashes and all LEDs
turned off. A single set is shown to program Menu 1 and three sets are
shown to program Menu 2.
3
Momentarily pressing a channel’s button enables timing value
programming for that channel. The channel’s current value will
be displayed. Also, the selected channel’s LED will blink yellow to
identify which channel is being changed.
5
When the desired timing value has been programmed, press the
channel button being changed to save the new setting and
return to Programming Mode.
NOTE: To return to Timing Mode without saving, momentarily
press the PRINCE CASTLE LOGO button.
2
Entering Programming Mode
Press and hold the PRINCE CASTLE LOGO button for 6-8 seconds to
enter the Programming Mode. The display changes to “Prog”.
4
Use the UP and DOWN arrow buttons to modify the timing value.
Pressing the UP arrow button will increase the timing value and
pressing the DOWN arrow button will decrease the timing value.
Each time the UP or DOWN arrow button is pressed the timing
value increases or decreases by one count.
NOTE: If either button is pressed and held, the timing value
begins to increase or decrease automatically with the change
rate increasing as long as the button is held.
When changes for all channels have been completed, press the
PRINCE CASTLE LOGO button to exit Programming Mode and
return the unit to an operationally ready, idle state.
6
