Horizontal Infrared Toaster
IRT-SB-NA-1PS
IRT-SB-NA-3PS
IRT-SB-NA-1PS
1
7
IRT-SB-NA-3PS
Remove Relay
Power off and Unplug the unit
1
WARNING
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
Using a Phillips head screwdriver, open the control
side panel. Reference the
Red Arrow
.
2
Remove 4 Wires from relay. Note the position of each
wire.
3
Using a Phillips head screwdriver, Remove (2) screws
to remove the relay. Refer to
Blue Arrows
.
4
# 2
**Close up shown for illustration purposes
# 4
# 4
Rel
ay
Rel
ay
Rel
ay
Replace Relay
Install the new board
5
Using the (4) screws removed in step 4, secure the
board onto the electronics tray
6
Reconnect (6) connections onto board that were re-
moved in step 4.
7
Using a Phillips screwdriver, secure the control side
panel to the unit. Previously opened in step 2.
8
Figure 1
Plug in unit. Power on and ensure the unit is fully
functional.
9
References
Printed in USA
12
/
3
/2020
353
-
56
7
Rev.
B
