537-5
28rev
C-EN
Printed in USA
2/06
© 200
6
5
TOASTER
TX-230
E
BKCE
8
Remove the plastic spline from the belt.
6
Release the upper and lower locking latches from the conveyor
rollers.
Upper Latch
7
Remove the conveyor belt.
Rotate the belt while removing
it from the side of the unit.
9
Reassemble the unit by reversing steps 1 - 8.
10
The conveyor belt has only one
contact surface and must be
re-installed with orange side facing
out.
The Teflon sheet uses both sides
as the contact surface. When
re-installing, rotate the usage by
turning top-to-bottom and/or
turning the sheet inside/out.
When reassembling convey-
or belt, make sure plastic
spline is positioned correctly
as shown.
When reassembling release
sheet, be sure to install upper
and lower retaining bars in
the correct end.
Release Sheet
Upper Retaining Bar
Release Sheet
Lower Retaining Bar
Place the belt and Teflon sheet on a flat surface. Clean
belt and sheet with
Sizzle Plus
multi-purpose cleaner
,
acceptable for use on food contact surfaces.
Lower Latch
